Lippye DRL Controller: Waterproof rating: IP67

Features

• Operating temperature range: -40°F to +185°F
• Maximum load: 240W
• Protection: short circuit, overcurrent, overvoltage, overheating
• Voltage for activation: 13.4V
• Voltage for deactivation: 12.98V
• Maximum current: 3A
• Maximum power: 60W
• Cable length: 1.97 feet
• Dimensions: 1.65x0.71x0.79 inches
• Warranty: 6 months
• Compatibility: 12V vehicles only
• Compatibility: halogen lamps only
• Power key type: Toshiba Automotive 60A
• Protection trigger level: 40A (500W)
• Brightness adjustment range: 15-45% with 5% steps
• Number of brightness levels: 15
• Delay time for turn-off: 15 seconds
• Number of management channels: 1
• Input voltage range: 10-16V
• Current consumption in standby mode: 8mA
• Switched voltage: up to 55V
• Switched current: up to 20A
• Lamp power: up to 130W
• Power supply voltage: 12/24V
• Control signal type: programmable rectangular pulses or voltage changes
• Number of configurable parameters: 12
• Compliance: GOST R 41.48-2004
• Models available: V.1-1.0, V.2.1-1.0, V.2.2-1.0, V.4-1.0, V.4-1.1, V.5-1.0
• Application: for LED DRL with/without drivers, for halogen lamps in reduced power mode
• PWM modes: for passive loads only
• Smooth on/off speed: user-adjustable
• Automatic mode adaptation to vehicle network characteristics
• Synchronization capability for multiple controllers
• Forced off via separate wire
• Home light function duration: 1-120 seconds
• Parking brake input for forced deactivation
• Brightness reduction when parking lights are on: 0-80% adjustable
• Threshold voltage adjustment for DRL activation
• Hysteresis: 0.4V
• Initial activation voltage: ~13.1-13.2V
• Initial deactivation voltage: ~12.8V
• Maximum load power: 30W
• Polarity of controlled output: positive
• Wire cross-section: from 1 sq.mm for LED lamps, from 1.5 sq.mm for incandescent lamps
• Fuse current: 3-7A for LED lamps, 7-10A for 21W incandescent lamps
• Weight: 0.033 lbs
• Dimensions: 0.79x0.79 inches
• Warranty: 2 years
• Factory calibration: activation at 13.5V, deactivation at 13.0V
• Maximum load: 50W
• Connection: without connectors
• Smooth activation: sharp
• Parking light mode: extinguishing
• DRL control: analog
• Input voltage: 10-16V
• Length: 0.79 inches
• Width: 0.79 inches
• Weight: 0.033 lbs
• Warranty: 2 years
• Board version: 2024
• Service life: ~6 years
• Stabilizer: built-in
• Resistors and stabilizers: Taiwan production
• Stable control current: 3A
• Control by amperage and voltage
• Full protection against short circuit and circuit overload
• Plastic housing: fully filled
• Controller: own production
• Maximum load: 5A (60W)
• Wiring length: 0.26 feet
• Activation voltage: 13.4V
• Deactivation voltage: 12.98V
• Maximum load current: 2A
• Activation voltage: 13V
• Operating voltage: 13-18V
• Turn-off delay time: 15 seconds
• Input wire length: 1.64 feet
• Output wire length: 0.43 feet
• Dimensions: 1.57x0.83x0.71 inches
• Weight: 0.077 lbs
• Fuse: 2A
• Parallel connection required for DRL lamps
• White wire for connection to low beam or fog lights
• Brightness reduction to half when lights are on
• Waterproof rating: IP67